77777
English
English
English
English
English
BIOSTAR Motherboard
S
ection 5. Installation and Setup
In this section, you will learn how to install the CPU, DDR
Module, and also how to set up jumpers and all the information
about the components on the motherboard. Not only can you find
the installation steps, but also the details and locations of the
components on the motherboard.
1. CPU Installation
The motherboard supports AMD processor in the 754 pin package. The
motherboard uses a CPU socket called PGA754 for easy CPU installation. When you
are installing the CPU, make sure the CPU has a cooling fan attached on the right to
prevent overheating. If you do not find the cooling fan, contact your dealer and make
sure to install them before turning on the computer.
Step1:
Pull the lever sideways away from the socket and then raise the
lever up to a 90-degree angle.
Step2:
Look for the white dot/cut edge. The white dot/cut edge should
point towards the lever pivot. The CPU will fit only in the
correct orientation.
Step3:
Hold the CPU down firmly, and then close the lever.
Step4:
Put the CPU fan on the CPU and buckle it. Connect the CPU fan
power cable to the JCFAN1. This completes the installation.
2 Central Processing Unit: CPU
These fan headers support cooling fans built in the computer. Orient the fans to
make the heat sink fins to allow air flow to go across the onboard heat sinks instead of
the expansion slots. The fan wiring and plug may be different according to the fan
manufacturer. Connect the fan cable to the connector while matching the black wire to
the ground pin.
(1) CPU Fan Headers: JCFAN1
Pin
Assignment
1
Ground
2
+12V
3
FAN RPM Sense
3
1
Step 2
Step 1
Step 3
Step 4
