K8M800-M7A BIOS Setup
26
Super IO Device
Press Enter to configure the Super I/O Device.
Figure 5.3: Super IO Device
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) installed on
the system board and you wish to use it. If install and FDC or the system has no
floppy drive, select Disabled in this field.
The Choices: Enabled
(default), Disabled.
Onboard Serial Port 1
Select an address and corresponding interrupt for the first and second serial
ports.
The Choices: 3F8/IRQ 4
(default), Disabled, Auto,
2F8/IRQ3,
3E8/IRQ4, 2E8/IRQ3.
Onboard Serial Port 2
Select an address and corresponding interrupt for the first and second serial ports
The Choices:
2F8/IRQ 3
, Disabled (default), Auto, 3F8/IRQ4
,
3E8/IRQ4, 2E8/IRQ3.
UART Mode Select
This item allows you to determine which Infrared (IR) function of onboard I/O
chip.
The Choices:
ASKIR,
IrDA
(default), SCR.
