Biostar IDEQ 330P, Supplementary Manual

Page: 10 / 23

Floppy Disk Connector: FDD1 (optional)
The motherboard provides a standard floppy disk connector that supports 360K, 720K, 1.2M,
1.44M and 2.88M floppy disk types. This connector supports the provided floppy drive ribbon
cables.
Hard Disk Connectors: IDE1/IDE2
The motherboard has a 32-bit Enhanced PCI IDE Controller that provides PIO Mode 0~5, Bus
Master, and Ultra DMA 33/66/100/133 functionality. It has two HDD connectors IDE1 (primary)
and IDE2 (secondary).
The IDE connectors can connect a master and a slave drive, so you can connect up to four hard
disk drives. The first hard drive should always be connected to IDE1.
Peripheral Component Interconnect Slot: PCI1
This motherboard is equipped with 3 standard PCI slot. PCI stands for Peripheral Component
Interconnect, and it is a bus standard for expansion cards. This PCI slot is designated as 32 bits.
Serial ATA Connectors: JSATA1~JSATA2
The motherboard has a SATA Controller in nForce4 (CK8-04) with 4 channels SATA interface, it
satisfies the SATA 1.0 spec and with transfer rate of 1.5Gb/s.
Connectors, & Slots
2.6
1
4 7
Pin
1
3
5
7 Ground
TX-
RX-
Ground
Assignment Pin
2
4
6 TX+
Ground
RX+
Assignment
How to setup Jumpers
2.7
Detail Settings
2.8
The illustration shows how to set up jumpers. When the jumper cap is placed on pins, the
jumper is “close”, if not, that means the jumper is “open”.
ATX Power Source Connectors:
JATXPWR1/JATXPWR2/JATXPWR3
JATXPWR1: By connecting this connector, it will p12V to PCI-Express x16 slot.
JATXPWR2: This connector allows user to connect 12-pin power connector on the ATX power
supply.
JATXPWR3: By connecting this connector, it will p12V to CPU power circuit.
Pin opened Pin closed Pin1-2 closed
Pin
1
2
Pin
1
2
3
4
5
6
Pin
1
2
Assignment
Assignment
Assignment
+12V
+12V
+3.3V
Ground
PW_OK
+5V SB
Ground
+5V
+12V
+12V
Pin
3
4
Pin
7
8
9
10
11
12
Pin
3
4
Assignment
Assignment
Assignment
Ground
Ground
+3.3V
Ground
PS_ON
+12V
Ground
+5V
Ground
Ground
1 6
7 12
JATXPWR1
JATXPWR3
JATXPWR2