Operation Manual BioSmart
BioSmart PalmJet, BioSmart PalmJet BOX,
BioSmart PalmJet BOX-T
v.049.1|03.2021|en
Page 7 of 39
Figure 2
–
BioSmart PalmJet BOX reader
BioSmart PalmJet BOX-T reader is equipped with a built-in sensor for measuring body temperature
in the wrist area and is shown in Figure 3.
Figure 3
–
BioSmart PalmJet BOX-T reader
1.
Light indicator of operating modes
2.
Palm vein scanner
3.
Field for reading RFID-cards
4.
Temperature measuring sensor (only for BioSmart PalmJet BOX-T)
Construction and Work
The reader works under the BioSmart SmartHub software service control or under the BioSmart
UniPass Pro controller control.
The reader, powered and connected to the BioSmart SmartHub software service or the BioSmart
UniPass Pro controller, enters into palm/card standby mode, according to the set operating mode.
When an object is brought to the palm vein biometric scanner, this object parameters are analyzed.
If the attached object is recognized as the palm of a living person, and biometric data of sufficient quality
may be read from the palm, then the biometric data is scanned in the infrared range. The read biometric
data is transferred to the BioSmart UniPass Pro controller or to a computer with the BioSmart SmartHub
software service. Next, the obtained biometric data is compared with the palm vein patterns stored in the
database. If a template was found in the database, deviations from which fall within the specified limit, the
1
2
3
4
