f) You can adjust the level of your arm by putting a cushion under
your arm. Ideally the cuff should be at heart level.
g) Remain seated in a comfortable room temperature for at least 5
minutes, then start the measurement.
h) For those who cannot put the cuff on the left arm, put it on the
right arm as shown.
i) Consecutive measurements will cause blood accumulation
in the lower arm which will affect the measuring results. To
improve reading accuracy, raise the arm being measured,
squeeze and relax your hand several times, then take another
measurement. Another option is to take the cuff off and wait
at least 5 minutes before repeating measurement.
j) If this device was stored in low temperature, it is necessary to
leave it in room temperature for at least 1 hour, otherwise the measurement can be inaccurate.
#OMMENT
If it is not possible to fit the cuff to your left arm, it can also be placed on the right arm. However all
measurements should be made using the same arm.
Comparable blood pressure measurements always require the same conditions (Relax for several minutes
before taking a measurement).
!44%.4)/.$ONOTUSEACUFFOTHERTHANTHEORIGINALCUFFCONTAINEDINTHISKIT
0ROTOCOL3OFTWARE$-ODE
7D Mode is used in consultation with your physician for assessing white coat hypertension or sustained
hypertension, based on a protocol of measurements taken at home. The protocol calls for 2 measurements to
be taken in the morning (AM) and 2 measurements in the evening (PM) for 7-days consecutively. The blood
pressure monitor will automatically average the measurements according to the protocol and will indicate
whether all data was fulfilled, at the proper times.
7D Mode simplifies the process for users and provides
physicians with clear data from home measurement.
1. When the monitor is OFF, press the
SET
button, a small triangle will appear above
7D Mode on the monitor. Press the
SET
button to confirm.
./4%0RESSTHEhvORhhBUTTONSTOSWITCHBETWEEN$-ODEAND
General Mode
.
2. Next, select the user. When taking measurements in 7D Mode it is very important
to select the correct user. Press the
SET
button to confirm, then press the
34!24
34/0
button to power the monitor OFF.
7D mode General mode
f)
h)
i)