BIOS AP DVPro DVT10T2, User Manual

Page: 25 / 75

DVT10T2
－
22
－
● Address Mask Setup
Address Mask
255.255.255.0
This is to setup IP address mask same as IP setup.
● Parity Mode Setup
ENABLE
PARITY
ENABLE*
、
DISABLE
Enable or Disable Cache memory parity. (Similar to ECC function)
● Maximum negotiable speed of host channels
eSATA Host
Speed 6Gb/s
3Gb/s, 6Gb/s*
It is important to note that the device eSATA speed is not auto-negotiable. Most of eSATA rate of host
computer is auto-negotiable, so this parameter has to be equal or smaller than the eSATA rate of host
computer.
●NCQ MODE
NCQ MODE
NO QUEUING
NO Priority, NO Queuing, Read Priority*, NO
Reorder
Set up NCQ (Native Command Queue) support, default is READ Priority. Options are listed as below
NO QUEUING *: No Queuing
READ PRIORITY : NCQ ON, higher priority for READ command
NO REORDER : Queuing ON, command executed as first in first out
NO PRIORITY : Queuing ON, command executed as possible re-order without special priority
*Native Command Queuing supports usually have dependency on host Operating System and SATA
Drive. When any abnormal behavior encountered, please set this parameter to NO Queueing. To
support NCQ, host has to set up operating mode of connecting SATA port as AHCI mode.
●AUX PORT MODE
AUX PORT MODE
0
0, 1, 2, 3
Definition of SGPIO and Breakout cable usage should not be changed.
0: Each miniSAS supports sideband SGPIO LED control and LCD control via 9 pin connector
● Disk Speed
Disk Speed
3Gb/s
3Gb/s