FOTS100 User Manual
© Opsens Inc.
IMP0023 Pico-M Manual rev 2.1 test.doc
7
MENU
LOG
2. Local Operation
2.1 Keyboard
MENU
LOG
2.1.1 Switch on/off
The FOTS100 is switched on/off with this button.
2.1.2 Menu Button
Menu button gives access to the system menus. Once in the menu, this button
brings the user one level higher into the menu hierarchy. Once at the root, the
system will exit the menu and goes back to measurement display.
2.1.3 Left/Right Arrows
Left/Right arrows allow moving from one digit to the other when a value is
being entered.
2.1.4 Up/Down Arrows
Up/Down arrows allow navigating 1) between menu items of a given
hierarchical level, or 2) it allows changing a value being entered.
2.1.5 Confirmation button
Confirmation button permits confirming 1) a new value being entered, 2)
confirm the selection of a menu item then moving one hierarchical level lower,
3) refreshing displayed value in the case of diagnostic.
2.1.6 Log button
(Reserved for future use)
2.2 System Setting
The functions below are used to setup specific parameters of the FOTS100.
2.2.1 Averaging mode
The user can set ON or OFF the averaging mode (ON by default). When on, the
measurements either displayed on the front panel display, output on the analog output or
on the RS-232 port is the result of the average of twenty sequential measurements
