while attaching the filter clip to the filter. Align
the clip on the side of your HEPA filter with the
rails on the inside of the unit.
NOTE:
The pleated material and rubber gasket
should be facing towards the unit when applied.
5. Align the clips on the side of your HEPA filter with
the rails on the inside of the unit. Gently slide
the filter onto the rails (see fig. 3).
6. Replace the inlet grill by sliding back on to the
unit. Make sure that it snaps securely into position
(the grill only goes on one way)
NOTE:
Do not point outlet towards wall.
7. The filter life indicator light (E) should be reset
once the HEPA filters have been replaced.
Reset the indicator by pressing the Power
button (
) on the control panel for 2 seconds.
REPLACEMENT FILTERS
BAPF30 HEPA Filter (usage 2 pcs)
Holmes Products (Europe) Ltd reserves the right
to change or modify any specifications without
notice.
For U.K. and Ireland only:
If the plug is not suitable for the socket outlets in
your home, it can be removed and replaced by
a plug of the correct type.
Please refer to "Installation of a plug" below.
Installation of a plug Applicable to
U.K. and Ireland.
WARNING - THIS APPLIANCE MUST BE
EARTHED
The wires in the mains lead are coloured as such:
GREEN AND YELLOW
- EARTH
BROWN
- LIVE
BLUE -
NEUTRAL
Please note that the colour of these mains wires
may not correspond with the colour markings
that identify the terminals in your plug.
Please proceed as follows:
The wire which is coloured GREEN AND YELLOW
must be connected to the terminal which is marked
with the letter 'E' or by the earth symbol
or
coloured GREEN or GREEN AND YELLOW.
The BROWN coloured wire must be connected
to the terminal, which is marked with the letter
"L" or is coloured RED.
The BLUE coloured wire must be connected to
the terminal, which is marked with the letter "N"
or is coloured BLACK.
NOTE:
If the terminals in the plug are not marked
or if you are unsure or in doubt about the installation
of the plug please contact a qualified electrician.
If a 13A 3-pin plug is fitted, it must be an ASTA
approved plug, conforming to BS1363 standard.
Replacement 3A fuses must be BSI or ASTA
BS1362 approved.
GUARANTEE
PLEASE KEEP YOUR RECEIPT AS THIS WILL
BE REQUIRED FOR ANY CLAIMS UNDER THIS
GUARANTEE.
• This appliance is guaranteed for 2 years.
• In the unlikely event of breakdown from a
manufacturing related fault, please return it to
the place of purchase, with your till receipt and
a copy of this guarantee.
• The rights and benefits under this guarantee
are additional to your statutory rights which are
not affected by this guarantee.
• Holmes Products (Europe) Ltd undertakes
within the specifiied period, to repair or
replace free of charge, any part of the
appliance found to be defective from a
manufacturing fault provided that:
• We are promptly informed of the defect.
• The appliance has not been altered in any
way or subjected to misuse or repair by a
TROUBLESHOOTING
Problem
Solution
Unit will not operate
Check to make sure the unit
is plugged in.
Check to make sure the unit
is on by pressing the Power
button.
Make sure the filters are
properly installed and firmly
close the door.
Decreased air flow
If the filters have not been
changed for 6 month or more,
change the HEPA filters.
Check to ensure nothing is
blocking the air inlet and
filtered air outlet.
Noisy
Ensure all plastic bags
have been removed from
the filters.
4
Holmes Products (Europe) Ltd
1 Francis Grove
London SW19 4DT
England
Fax: +44 (0)20 8947 8272
Email: [email protected]
Website address: www.bionaire.com
UK - Filter Sales Order Line - 0870 759 9000
UK - Free phone Customer Service Helpline – 0800 052 3615
9100040002921
BAP830RCSIUK07EM1
Tower Air Purifier
BAP830RCS
person other than a person authorised by
Holmes Products (Europe) Ltd.
• Faults that occur through normal wear and tear
are not covered by this guarantee.
• No rights are given under this guarantee to a
person acquiring the appliance second hand
or for commercial or communal uses.
• Any repaired or replaced appliance will be
guaranteed on these terms for the remaining
portion of the guarantee.
THIS PRODUCT IS MANUFACTURED TO
COMPLY WITH THE E.E.C. DIRECTIVES
73/23/EEC, 2004/108/EC and 98/37/EEC.
Waste electrical products should not be
disposed of with Household waste.
Please recycle where
facilities exist.
Check on the following website
for further recycling and WEEE
information:
www.bionaire.com or e-mail
[email protected]
5
© 2007 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All Rights Reserved.
BAP830RCS-IUK_07EM1.qxd 4/25/07 20:51 Page 1
