Questions? Call 888 302 3375
DPF1C control switch for
Level Series
,
Flexo Series
, and
Pro SuperPlus
and
Level 3Plus-95
desks with 5 legs.
NOTE:
DPF1C may or may not have digital display
Operating your Biomorph Desk
Setting Initial Height.
It may be necessary to adjust the displayed height due to different
thicknesses of desktops, or addition of casters, etc. The DPF1C will as
standard either show 68 cm or 24.5 inch as the default desk height.
Procedure
Press and keys at the same time and keep them pressed
for 5 seconds. This allows the initial height to be adjusted.
UP
DOWN
MEMORY 1
MEMORY 2
MEMORY 3
STORE MEMORY
DIGITAL DISPLAY
5 sec.
1
Until the initial height can be adjusted, the display will show three
minuses . Hereafter the display will revert to showing the
height. The height can then be adjusted by either or until
desired height has been reached. The system will return to
normal operation (and give a short blink) after 5 seconds of
inactivity on the keys.
2
Keep the button pressed until the position is reached. Release
button and press again to go past that position.
Press one of these memory buttons and the
system will start driving to the pre-programmed memory position.
1
2
Display function (only included on dual or multiple drive tables)
shows the actual height in either cm or inch.
3
To Set Memory.
These buttons are used for memory drive/storing
memory. To store memory:
Press . The display will flash for 2 seconds. Within these two
seconds press one of these buttons and the position
will be stored at this button.
1
The panel will acknowledge by showing , or in the display
depending on chosen position (if panel is included).
2
Memory Drive.
To Raise or Lower Height in Regular Use.
Push the button to
raise
the height or the button
to
lower
the height. The
system will move until the
button is released again or
the system reaches end
position.
48.6”
22.1”
Side View
©2021 GSE (US) LTD.
