Manual - BioSpot BT600 workstation
page 7 of 15
indication for power supply (illuminates while the BioSpot BT600 is switched on and
connected correctly to the power supply)
dispense LED red/ yellow
indication for a dosing event (illuminates at each dispense)
move LED blue
indication for axes movement (illuminates while any axis x/y/z is moving)
power toggle switch (back side)
enables the power supply of the BioSpot BT600. Using this switch supplies all components
with power, including PC and dosing electronics.
emergency switch
Pressing the emergency switch disconnects all internal components from the power supply,
except the internal PC and the power switch on the back side. The emergency switch can be
used to stop non-intended movement of one of the axis or non-intended dosage.
PLEASE NOTE:
After using the emergency switch, the axes need to be re-referenced!
Further, it is required to re-boot the internal PC after pressing the emergency switch in order
to put the BioSpot back into operation.
Dispenser connection
Connector sockets for up to 8 PipeJet dispenser units; U = 0 to 180V
Warning:
High voltage hazard at plugs and sockets!
USB connector
Standard USB 2.0 connector, intended for the connection of a TopView camera
(may be ordered separately)
Connection for ring-light
Current controlled connector for the TopView camera illumination
(may be ordered separately)