9
7
For more information about BioEngergiser Products visit our website at: www.globalproductcom
For more information about BioEngergiser Products visit our website at: www.globalproductcom
6
HOW TO OPERATE
FOR BODY
FIG. 4
Fig. 1
Fig. 2
Fig. 3
For Foot ‒ SOLE
Tips: In order to increase the conduction, apply
Circulation Reviver
TM
Foot gel on your sole.
1.
Place your bare feet onto Circulation Reviver
TM
(do not wear
socks).
2.
Press the on/off button, the LCD screen will light up in Orange.
And the program show AUTO and both Band shown in 00, which
is in standby mode. (see Fig. 1)
3.
Gently increase intensity setting by pushing the button of “
SOLE +”. Or decrease intensity setting by pushing the button of “
SOLE -”. The intensity level is adjustable between 0 and 99. The
LCD display will show the selected level. (see Fig. 2)
4.
You can adjust the auto off timer by pressing the “Time ‒“ or “
Time +”. Timer range from 1-60 minutes. To terminate the
massage period, user can turn off the unit anytime by pressing
the on/off Button once. And the timer start to count down from
your time setting (see Fig.3)
5.
If you satisfaction on the current massage program then you
can lock the current massage programme by press the
Auto/Mode key, then the rest of the massage time will only run
the selected massage program. (see. Fig. 4)
A.
The aim is not to get up to ʻ99ʼ.
B.
Chose an intensity level that is comfortable for you!
This level may vary from day to day.
C.
Remember to drink plenty of fluids ‒ if you are dehydrated,
this will reduce the effectiveness of the device.
D.
If you have dry feet ‒ moisturise them or apply
Circulation Reviver
TM
Foot Gel for maximum health benefits.
Important Information:
1.
Plug in the 2 cable into the cable jack on the unit.
(see Fig. 5)
2.
Connect pin of the cable to the gel pad properly.
(see Fig.6)
3.
Remove the protective film on the gel pad, and
attached the 4 gel pads to the area of the body you wish
to treat.
4.
Repeat operation as in foot instructions, adjust the
intensity using for body .you wish to treat.
5.
Gently increase intensity setting by pushing the
button of “Body + ”. Or decrease intensity setting by
pushing the button of “Body - ”. The LCD will also show
the level which you have selected (see Fig. 7).
6.
To terminate the massage period, user can turn off the
unit anytime by pressing the on/off Button.
Never stick two adhesive pads to each other. Keep the
adhesive gel pads clean, never expose them to high
temperature or direct sunshine. If the electrode gel pads
are insufficiently adhesive or dirty, wipe with a wet cloth
or change for new ones, replacement parts will be
available directly from BioEnergiser or your distributor.
ALWAYS
try and protect the gel pads. Store the gel pads
on the gel pad protector when not in use, as in the
illustration.
Wash and dry skin before use. Connect the output wire
to the gel pads. Connect the other end of the output
wire to the output jack on Circulation Reviver
TM
. Remove
the protective film from the adhesive pads. Attach the
gel pads to the skin. Press the on/off button to turn on
the unit and adjust the stimulating output intensity to
the desired level. (The display will show the mode and
level that you selected and start to count down).
Using The Gel Pads
Care Of Your Gel Pads
Do not clean the electrode gel pads with any
chemical.
Fig.5
Fig. 7
Fig. 6
A
B
ENGLISH