15
(2)
: To control blower working status. Blower has memory function that blower can display last
time blower gear, to avoid needing to adjust the fan gear each time. (Note: It will not work when
front window is fully closed)
(3)
: To control fluorescent lamp.
(4)
:To control UV lamp (UV lamp, blower, fluorescent lamp and front window interlock; it
won’t work when fluorescent lamp, blower and front window open )
(5)
: To control socket power status.
(6)
: Press Down button, glass window will fall down. Each time you press, the buzzer will sound;
hold down this key, the glass door will continue to decline; release the button, the glass door will
stop declining.
(7)
: Press UP button, glass window will raise. Each time you press, the buzzer will sound ; hold
down this key, glass doors will continue to rise; release the button, the glass door will stop rising.
(8)
:To control blower speed down. When blower is working, if
▊
number is more than 1, each
time you press, wind speed can reduce a gear, and the buzzer rings once, until one
▊
appears. Press
this button when you use the UV lamp, UV lamp timing time decreases, and the minimum time is 10
minutes, set time can be remembered.
(9)
:To control blower speed increase. When blower is working, if
▊
number is less than 9, each
time you press, wind speed can increase a gear, and the buzzer rings once,
until
▊▊▊▊▊▊▊▊▊
appears. Press this button when you use the UV lamp, UV lamp timing
time increases, and the maximum time is 90 minutes, set time can be remembered.
(10) LCD display: When powered on, from top to bottom is
▊▊▊▊▊▊▊▊▊
FAN, It indicates
the strength of blower wind speed; Shown below is the current state of the Winds; The right of the
display is time; UV TIME, UV lamp working time; WORK TIME: HEPA filter working time.
(11) Clock Adjustment: In standby mode, press light button continuously to enter clock setting mode
after a buzzer alarm. Firstly, minute position is flashing, press UP and DOWN to adjust to present
time. Then press the blower button switching to hour position and adjust to present time. After that,
press the light button again, data will be saved after a buzzer alarm.
(12) UV lamp timing: In standby mode, when the front window is lowered to a minimum, please
press UV lamp control button
, then the UV lamp is opened. After opening the UV lamp, the
display will show the current status of the UV lamp timing: By pressing blower speed down button ,
the setting time will be reduced one minute each time; by pressing blower speed up button
, the
setting time will get be increased one minute each time. You can set the time as needed (UV lamp
timing range is 0-90 min, and the max factory setting is 90 min)
6
）
Motorized glass door control