1. Press the hook
once; wait for the
flashing red and
blue light;
2. Put your finger on the sensor
and wait for the solid blue light;
*If a red light flashes, please
put your finger on the sensor and
try again.
3. Repeat step 2 for three times
until you see a solid blue light
flashing for 4 seconds, that
indicates the successful
enrollment of the fingerprint.
Activation
Press hook to activate the lock:
Note:
If the LED light is not activated, please
charge the lock using micro-USB.
If no action is proceeded within 15
seconds after the lock is activated, the
power will be turned off
automatically.
TouchLock is a smart padlock. There is no need for keys or combinations.
The lock can store up to 20 fingerprints which easily allows you to share your lock
with your family and friends. Our TSA lock and TouchLock XL also comes with a
waterproof rubber ring which is specially designed for all outdoor usage of the locks.
TouchLock
TM
Fingerprint Enrollment
Unlock
1. Press the hook
once and wait for the
flashing blue light.
2. Put your enrolled finger on the
touch sensor and hold until
you see the solid blue light;
*If a red light flashes, please
put your finger on the sensor
and try again.
3. TouchLock will then
unlock.
Enrollment of Additional Fingerprints
1. Press and hold
the hook for 6
seconds until
you see a rapid
flashing blue
light.
2. Touch the sensor with the
previously enrolled finger until
you see the solid blue light.
* if a red light flashes, please
put your finger on the sensor
and try again.
3. Start enrolling the new fingerprint
when you see the flashing blue
and red light.
* Please refer to the Fingerprint
Enrollment section on page 1.
Charging
port
Sensor
LED
Hook
Waiting for Blue
light to touch
Blue light flash
Blue light flash
6 sec
*Refer to “Fingerprint
Enrollment” section
Red and blue
light flash
Waiting for Blue
light to touch
Waiting for Blue
light to touch
Water
resistant
ring
Flashing red
and blue light
Solid blue light
