• Fill the vat with water until the indicated level and, if desired, add crust removing solution in the
proportion specified by the manufacturer;
• Before connecting the Washer power cord in the outlet, check that the voltage of the device is
according to the local power supply. After connecting the cable, the board will light up
automatically;
• Through the key “SET” determine the washing cycle time shown on the display of the washer
board. Each touch on this key changes the cycle time respectively: 180, 280, 380, 480 or 90
seconds;
• Press the “ON” key to start the washing cycle;
• To pause or finalize the washing cycle, press the “OFF” key;
• To reschedule a new cycle press the “SET” key; or to continue the process where it last stopped,
simply press the “ON” key;
• At any moment during the operation, the washing cycle time can be changed by pressing the
“SET” key until the new desired time is obtained.
• At the end of each cycle, the display will shows the numbers “000” indicating the end of the cycle.
NOTE:
This machine is equipped with a protection circuit against overheating. When the
temperature limit is reached, the LED indicator Overload protection (LED located right panel)
will be red, interrupting the cleaning cycle. At this point the cleaning process will not work, even
by pressing the “ON” key. The equipment will stop for about 15 minutes to cool down. After this
period, by pressing the “ON” key the ultrasound functioning indicator (LED located at the right
of the board) will light green and the machine will again function normally.
USE OF HEATING:
• To actuate the heating system, press the “TC” key;. The red light located on the left of the board
will light, indicating that the heating system is ON. When the water temperature reaches about
65 ºC the luminous indicator turns off indicating that the heating system was turned off;
• To turn off the heating system before the end of its cycle, press the key “TC” key. At this moment
the red light located on the left side of the panel will go out indicating that the heating system was
turned off.
ATTENTION!
Never use the appliance without water. This will shorten the life of the
equipment causing the total loss of the equipment (loss of warranty).
!
- 04 -