BinTec X4100, Installation Manual

Page: 30 / 36

Installation of the Expansion Card and Resource Card(s)
2
30 BinTec Access Networks GmbH
2.2.2 ISDN-PRI Expansion Card /
G.703 Expansion Card
The ISDN-PRI card can be fitted with a maximum of two resource cards with
digital modems.
Proceed as follows:
➤
Take the resource card out of the antistatic bag.
Figure 2-6: First resource card with digital modems with ISDN-PRI card
➤
Mount the spacer pins (if not pre-assembled) on the expansion card (see
figure 2-6, page 30 ): Place a washer from above onto the corresponding
Phillips screw, fix the screw from below up through the expansion card, and
then mount the spacer pins.
➤
Place the first resource card down onto the corresponding connector (see
figure 2-6, page 30 ).
➤
Fasten the resource card by fixing the included screws into the spacer pins.
➤
If necessary, connect the second resource card from above onto the sec-
ond connector (see
figure 2-7, page 31 ).
1 First resource card with digital
modems 3 Connector for first resource
card
2 Spacer pins 4 Screws
1
2
2
2
2
3
4
4