OPERATING NOTES:
1. Connect resin hose to right hand fluid inlet and tighten
securely (see figure 3).
2. Connect catalyst hose to left hand fluid inlet and tighten
securely (see figure 3).
3. Once installed, do not reverse hoses and gun fluid
passages.
4. With nozzle tips removed, open catalyst supply line and
start resin pump slowly. Direct gun into a suitable con-
tainer and depress trigger to purge air from the hose.
5. Release trigger, engage trigger lock and replace nozzle
tips. (See figure 1.)
6. If fiberglass chopper accessory is used, connect air
hose to gun (see figure 3).
7. Set catalyst pressure, increase pump fluid pressure
gradually and test spray pattern for proper atomization.
8. While spraying, the trigger must be fully opened or
closed. You cannot feather with an airless gun.
9. Always engage trigger lock (see figure 1) when gun is
not in operation.
NOTE
Do not use fluid pressures above those required for proper
atomization. Excessive fluid pressure causes undue wear on
nozzle tips, fogging, and waste of material.
MAINTENANCE NOTES:
1. To clean nozzle tips:
a. Engage trigger lock (see figure 1).
b. Remove nozzle caps, nozzle tips, and gasket.
c. Submerge nozzle tips in solvent to loosen any par-
tially cured material to aid in cleaning. (Do not use
metal objects.)
d. Blow air through nozzle tips to insure orifice is clear
of any obstruction.
e. Reassemble in reverse order.
2. To repair air valve assembly (if using chopper):
a. Shut off air to gun, release air pressure and engage
trigger lock (see figure 1).
b. Remove the valve assembly, seal, and spring.
c. Remove actuator assembly by unscrewing from
plastic head.
d. Remove screw from body. Packing can be removed
and replaced if necessary.
e. Reassemble in reverse order.
3. To repair needle assembly:
a. Shut off material supply to all components and
release pressure in hoses. Remove hoses from gun.
b. Remove trigger screw and trigger stud and remove
trigger.
c. Remove nuts from needle assembly.
d. Remove packing nut, spring, and needle assembly.
e. Remove packing from needle assembly and replace
if necessary.
f. Reassemble in reverse order.
4. To replace seats:
a. Remove seat housing, needle assembly, spring, and
packing nut as one assembly.
b. Remove seats with hex key. Add thread tape to
threads when replacing to prevent leakage.
c. Reassemble in reverse order.
3/13 ©2013 Binks All rights reserved. Printed in U.S.A.
Binks Sales and Service: www.binks.com
WARRANTY
This product is covered by Binks’ 1 Year Limited Warranty.
77-2070R-7 Revisions: Trademark updates; (P2)
Added Prop 65 warning; (P4) Updated contact
information.
U.S.A./Canada Customer Service
195 Internationale Blvd.
Glendale Heights, IL 60139
630-237-5000
Toll Free Customer Service
and Technical Support
800-992-4657
Toll Free Fax
888-246-5732
