Binks 104020-M2, Instruction Manual, Page: 13 / 16

Instruction Manual
Page 13 of 16 77-3236-R3.0
Installation
This product should be flushed with a suitable compatible solvent prior to use.
Mount the pump securely and position the pump at a convenient height (below the
lid height of the paint container), to allow for maintenance, visual observation, and
periodic inspection. The wall mount bracket is included with all pumps.
The Pump Mounting bracket must be connected to a suitable earth ground to ensure
that there is no possibility of static build up.
Attach suitable flexible hoses to the inlet and outlet connections. Connect a suitable
3/8” – ½” NB air hose and ½” Pressure Filter Regulator to the air motor. (Filter rated
at minimum 1000 L/min)
No additional air lubrication is required as piston ring lubricant is applied during
assembly or repair. If an air lubricator is used then this must be maintained.
Set the pump speed to a slow cycle rate and start the pump to remove any air from
the fluid circuit before increasing pressure. Inspect for any air or fluid leaks.
If an air blow out system is used, never exceed 2 Bar on the inlet of the pump.
Exhaust kits are available for these pumps if the air exhaust is required to be piped
away from the pump rather than exhausting locally through the mufflers.
Accessories
Part No. Description Remarks
192008 1½” Sanitary Gasket
192009 1½” Sanitary Clamp
502608 Seal Insertion Tool For Shaft seal (5)
502682 Bellows Assembly Tool
502681 Bellows Assembly Spigot
AGMD-010 Kluber Isoflex Topas NB 52 (Grease type #) 50 ml Tube
192779 Exhaust Tube Adapter (1” NB hose) For piped exhaust
192820 Exhaust Tube Adapter (1¼” NB hose) For piped exhaust
192803 1” Manifold Plug For piped exhaust