6
How to control the length
7
How to bind and print
CAUTION!
Please surely check the
tape direction
when install the tape and push the tape roll to
machine body.
[Manual Mode]
1. The unit is in the manual operation mode after tape feeding.
2. Put 100bills to be bundled inside the tape ring. (The start
button will start blinking if the automatic sensor detects the objects.)
3. Press the start button and then binding and printing operation will begin, and the tape will be
cut off at the same time. After binding with printing, more tape will be in place for the next
bundle.
*To be converted to manual mode, press Auto button
[Automatic Mode]
1. Press the automatic button, then it will be lit up and the unit will switch to the auto mode.
2. Put 100bills to be bundled inside the tape ring in place.
3. The objects are automatically bundled when the sensor detects them
*During automatic operation, Bundling is performed without the Start button being pushed.
Use the length control volume to adjust the length of tape
Short
Long
[Preparations]
1. Connect the power cable to the power inlet.
(the fuse hold and power switch are integrated).
2
.
Turn the power switch on.
3. Feed the unit with tape as explained above.
4. Push down the toggle switch than will convert
to strapping mode
5. Power(red)button is blinking and start(green)button is
on at the same time press power button.
Start(manual)button
버튼
Auto Button
