Binder KBF 115 (E5.2), Operating Manual

Page: 53 / 103

KBF / KBF P (E5.2) 02/2012 page 53/103
9.7 Repetition of a section or several sections within a program
Here we use the example of a set-point ramp temperature program of chap. 9.5. The shaded sections 02
and 03 shall be repeated e.g. 30 times.
Program
section
Set-point
temp.
Fan Section
time
Operation
lines
Target
section
No. of
cycles
Min.
tolerance
Max.
tolerance
01 40 100 % 00:30:00 Off 1 0 -1999 +9999
02 60 100 % 01:30:00 Off 1 0 -5 +5
03 90 100 % 01:00:00 Off 1 0 -2 +2
04 90 100 % 03:20:00 Off 1 0 -1999 +9999
05 20 100 % 00:00:01 Off 1 0 -1999 +9999
The following table shows the program that results, whereby the differences to the table above are shad-
ed.
Program
section
Set-point
temp.
Fan Section
time
Operation
lines
Target
section
No. of
cycles
Min.
tolerance
Max.
tolerance
01 40 100 % 00:30:00 Off 1 0 -1999 +9999
02 60 100 % 01:30:00 Off 1 0 -5 +5
03 90 100 % 01:00:00 Off 2 30 -2 +2
04 90 100 % 03:20:00 Off 1 0 -1999 +9999
05 20 100 % 00:00:01 Off 1 0 -1999 +9999
Sections 02 and 03 will be executed in total 31 times; only then will the program continue.
Entry of the values into the display program table:
To have sections repeated infinitely, enter the number of cycles “Cy” as -1.
9.8 Performance after power failure in Program Mode
The program is resumed at the point where the interruption occurred with the latest set-points reached
during the program run. The power failure is noted in the event list. No error message is displayed indicat-
ing that a power failure had taken place.
08:43:55 15.12.09