Binder KB 115 (E4), Operating Instructions Manual

Page: 116 / 149

KB (E4 + E6) 02/2017 page 116/148
19.8 Water protected internal socket (option)
You can turn on and off the interior socket via the controller menu (chap. 7.1).
The internal socket is splash proof.
IP system of protection 67 with plug or lid,100-240 V 1N ~ 50-60 Hz
Charge max. 500 W
Maximum permitted operating temperature with this option: 90 °C / 194 °F.
WARNING
Exceeding the permitted maximum temperature.
Electrical hazard.
Danger of death.
Damage to the internal socket.
∅
Do NOT exceed the temperature set-point of 90 °C / 194 °F .

Set the safety controller to 90 °C / 194 °F .

With optional temperature safety device, class 3.3, set the mechanical thermostat
class 3.1 to 90 °C / 194 °F .
Heat emission of electrical devices connected inside the chamber may modify the temperature
range.
CAUTION
Risk of short circuit.
Damage to the chamber.

Use the supplied plug only (IP protection type 67). Plug it in and turn it to secure con-
tact.

If the socket is not used, close the screw lid and turn it to secure.
Turning on and off the voltage of the interior socket is possible at the chamber controller through Menu >
Optional equipment > Interior socket , see chap. 7.1. Turning off the incubator at the main power switch
also switches the interior socket voltage-free.
Figure 16: internal socket
(front view)
Figure 17: Supplied waterproof plug (front view)
19.9 Interior lighting
Opening the door activates the interior lighting. When closing the door, the interior lighting goes off again.
Pin 1 Pin 2
PE
Pin 3
Pin 2 Pin 1
Pin 3
PE