Binatone TP-4070, Instruction Manual

Page: 6 / 34

6 66 66
! To avoid electrical current shocks, to not put the thermopot on ice
to cool the water in it.
!
Do not distort the power cable and do not place it near a source
of heat. Do not wind the power cable around the appliance and
do not put heavy objects on the cable.
!
Only use a dry cloth to remove dust from the power cable plug
or its contacts.
!
While disconnecting the appliance from the power grid, to do
not pull the power cable - grasp hold of the plug and pull!
!
Let the appliance completely cool down before cleaning or stor-ing.
!
Always disconnect the appliance from the power supply during
long-term storage, before filling the appliance with water or emp-
tying and before relocation of the appliance. While trans-porting or
storing the appliance make sure its empty of water.
DESCRIPTION
OF COMPONENTS
1. Casing (Fig. A) (Fig. A) (Fig. A) (Fig. A) (Fig. A)
2. Internal bulb
3. Removable lid (Fig. B) (Fig. B) (Fig. B) (Fig. B) (Fig. B)
4. Lid valve
5. Steam discharge port
6. Manual pump button
7. Lever for manual pump locking «Lock/Open»
8. Control panel (Fig. C) (Fig. C) (Fig. C) (Fig. C) (Fig. C)
Buttons:
«Boil» — boiling
«Dispense» — filling
«Unlock» — unlocking
«Cooling» — cooling
«Temp Set» — temperature setting
Indicators:
«Boil» — boiling
«Keep warm» — warming
«Unlock» — unlocking
«Cooling» — cooling
9. «Cup switch» valve
10.Water supply port
11.Handle
12.Rotating base
13.Water level scale
14.Power cable slot
15.Detachable power cable
16.Lid locking valve
INSTRUCTIONS FOR USE
1. Place the appliance on a dry horizontal surface.
2. Open the lid (3) (3) (3) (3) (3) by pulling the lid locking
valve (4) (4) (4) (4) (4) upward.
3. Fill the thermopot with water.
4. Make sure that the water level is not above a
mark «Full» on the water level scale (2). (2). (2). (2). (2). Do