7+,6 6,'( 83
1L0+ $$
P$K9
1,0+ %$77(5< 3$&.
5(&+$5*($%/( %$77(5<
2. Installation
2.1 Removing the Belt Clip
a.
Pull the Belt Clip latch forward
(away from the PMR.)
While pulling the Belt Clip
latch, push up the Belt Clip
as shown in Figure 1.
b.
Figure 1
Figure 2
2.2 Installing the Belt Clip
a.
Slide the Belt Clip into the
slot as shown in Figure 2.
A “click” indicates the Belt
Clip is locked into position.
b.
Figure 3
b
Belt Clip
latch
Figure 4
2.3 Installing the Battery pack
Read these Safety Warnings before you charge the batteries.
Important
2.4 Charging the Battery pack
a.
Insert the small plug on the end of the mains adaptor into the
Power-in Connection Jack at the back of the desktop charger.
Plug the mains adaptor into a 2
4
0V AC, 50 Hz main socket with
the switch on the socket set to OFF.
Switch ON the main socket.
b.
c.
The PMR must be charged using the mains adaptor provided.
Using any other adaptor will result in non-compliance with
EN60065 and will invalidate any approvals & warranty.
a.
b.
c.
Slide down the Battery Compartment Cover.
Replace the Battery Compartment Cover. See Figure 4.
Install the rechargeable battery pack by following the orientation as
shown in Figure 3 (the arrow is showing and pointing upward.)
Caution: Observe the proper battery polarity orientation when
installing batteries. Incorrect positioning can damage both the
batteries and the unit.
c
When placing the PMR in the charger,
when you are charging the batteries.
never try to burn them or put them anywhere,
they could get burnt or punctured.
They might leak if you do.
use only the rechargeable
batteries supplied with the Terrain 550.
Don't try to recharge non-rechargeable batteries.
Make sure the battery compartment cover is securely locked in
place
Dispose of used batteries safely and in a way that will not harm
the environment -
Don't leave dead batteries in your PMR units.
