Binatone Newton SI-4440, Instruction Manual, Page: 6 / 38

6
BEFORE USE
w Remove all packaging from the appliance.
w Turn the steam control knob
(9)
into the
«0» position, and the temperature control
knob
(10)
– into the «Min» position.
w If you intend to iron with spray or steam, push
the cover
(4)
up and fill the tank
(5)
with
water through the opening
(3)
. Use the mea-
suring jug
(14)
for convenience and ease.
Note: If your area has hard water, we recommend you use
filtered or bottled water.
Attention: Always disconnect the iron from the electricity
mains supply prior to filling the tank (5) . Do not fill
the tank (5) with other liquids.
w
Prior to first use iron a clean old piece of cotton cloth to make
sure the sole plate and the water tank are absolutely clean
(see subsection «Steam ironing» ).
Note: Light smoke may emit during the first use of the appli-
ance: it is a normal occurrence that will soon disappear.
INSTRUCTIONS FOR USE
1. Place the iron into a vertical position.
2. Insert the power plug into the mains supply
outlet.
3. Turn the temperature control knob (10) to
set the temperature recommended by the
manufacturer of the textile article (usually
indicated on the article’s label).
Note: In case the manufacturer’s recommendations are
missing, select the temperature setting, which
corresponds to the type of the cloth to be ironed (see
section «Useful advice» ).
4. The temperature indicator (12) will light up to indicate that the
iron is being heated to the set temperature level. When the set
temperature level is reached, the indicator
(12)
will turn off.
Note: During operation of the appliance the light indicator
will light up and turn off periodically; this is normal
and not a malfunction.
Steam ironing
Dry ironing can be can be used at any temperature setting. To
do this the steam control knob (9) must be put into the «0» posi-
tion. If you intend to use the steam function, allow the iron to heat
to the required temperature level then put the control knob
(9)
into the required position.