Binatone CEJ-3300, Instruction Manual, Page: 5 / 28

5
ENGLISH
SPECIAL SAFETY MEASURES
Do not touch hot surfaces of the appliance.
Do not touch outer surfaces of the kettle with the
exception of the heat insulated handle, when water
is boiling or with hot water inside the device.
Allow kettle to cool prior to its cleaning and
storing.
Disconnect the appliance from the electricity
supply during prolonged storage, prior to filling it with water/
emptying it or prior to moving it from one place to another.
The appliance shall always operate on heat resistant, horizon-
tal and dry surfaces.
To avoid being burnt by hot vapor always close the lid tightly
prior to switching the device on. Avoid exposure to hot vapor.
WARNING! Never open the lid immediately before
of after boiling temperature is reached
.
Prior to switching the kettle on make sure the water level stays
not lower than the minimal mark and not higher than the
maximum mark at the water gauge. The kettle is protected
against overheating if switched on without water. In case of
overheating, an automatic safety cut out device will switch it off
in case of absence or excessively little quantity of water inside
the kettle. If the safety device is activated, allow the kettle to
cool down prior to boiling water in it. The kettle would not
switch on if it’s too hot.
WARNING! Frequent switching
the kettle on without water might result in the safety
device failure, that is why prior to switching the kettle
on always check the water level. Always make sure
the water level in the kettle is not too low.
Always switch the kettle off prior to lifting it from the base.
Use the kettle only with the supplied base.
Do not fill the hot kettle with cold water or vice versa.
WARN-
ING! Avoid sharp temperature fluctuations when fill-
ing the kettle with water.
Connect the device only to the electrical supply with protec-
tive earthing. If your socket has no protective earthing, con-
tact a qualified specialist. Do not modify the plug and do not
use cord adapters.
WARNING! Electric hazard might
occur if the kettle is plugged into the unearthed power
supply.
Clean the heating element of the kettle more often to descale
it. Remember that use of the heavily scaled kettle might result
in its malfunction.
WARNING! Descale the kettle using
only specially designed cleaning agents.
Before turning the kettle on, make sure that the lid is closed;
otherwise the kettle will not turn off after boiling.
After use of the appliance, the base of the kettle might be wet.
It is a normal condition of operation, caused by escaping steam,
used to activate the kettle’s automatic turning off function.
Do not tilt the filled kettle backwards, since water can spill
through the steam vent. If this happens, the kettle should be
wiped before turning it on.
Do not take the electric cord out of the socket during operation
of the appliance. You should first turn it off.