2. Installation
2.1 Removing the Belt Clip
2.2 Installing the Belt Clip
2.4 Charging the Batteries
a.
Pull the Belt Clip latch up
(away from the
Action 950
)
b.
While pulling the Belt Clip
latch,slide the Belt Clip up as
shown in Figure1.
Belt Clip latch
Figure 1
Figure 2
a.
Slide the Belt Clip into the
slot as shown in Figure2.
A “click” indicates the Belt
Clip is locked into position.
Figure 3
Figure 4
a.
Unclip the battery cover latch at the bottom of the cover, and lift
the battery cover off.
Important
Read these Safety Warnings before you charge the batteries.
When placing the
Action 950
in the charger,
use only the power
supplies listed in the user instructions supplied with the
Action 950.
Don’t try to recharge non-rechargeable batteries
.
Make sure the battery compartment cover is securely locked in
place
when you are charging the batteries.
Dispose of used batteries safely and in a way that will not harm
the environment-
never try to burn them or put them anywhere they
could get burnt or punctured.
Don’t leave dead batteries in your
Action 950
units.
They might leak if you do.
a.
Insert the small plug on the end of the mains adaptor into the
Power-in Connection Jack at the back of the desktop charger.
b.
Plug the mains adaptor into a 240V AC, 50Hz main socket with
the switch on the socket set to OFF.
c.
Switch ON the mains socket.
Using any other adaptor will result in non-compliance with
EN60950-1 and will invalidate any approvals & warranty.
2.3 Installing the Batteries
Caution: Observe the proper battery polarity orientation when
installing batteries. Incorrect positioning can damage both the
batteries and the unit.
b.
Insert the 4 “AAA” size rechargeable batteries by following the
c.
Replace the Battery Compartment Cover. See Figure 4.
+
/-
polarity marking inside the Battery Compartment as shown in
Figure 3.
Use only the mains adaptor provided.
