Binary B-660-EXT-444-100AS, Installation Manual, Page: 10 / 20

10
5.2. Wiring
Warnings:
• Before wiring, disconnect the power from all devices.
• During wiring, connect and disconnect the cables gently.
Steps for device wiring:
1. Connect HDMI IN
Connect the HDMI sources (such as PC, Blu-ray player, Apple TV, 4K media player, etc.) to
the HDMI IN of the transmitter.
2. Connect HDBT OUT
Connect HDBT OUT of the transmitter to HDBT IN of the receiver with Cat 5e/6/7 cables.
3. Connect HDMI OUT
Connect HDMI display device (such as TV, projector) to the HDMI OUT of the transmitter
and receiver.
4. Connect Audio Outputs
Set the front panel Function1 DIP switch to down or “audio de-embedding” mode, and
connect to the SPDIF OUT or AUDIO OUT port.
5. Connect for additional control options:
• IR Pass Through: Connect the IR emitter cable to the IR Flasher port or the IR receiver
cable to the IR Receiver port of the transmitter, and connect the IR receiver cable to
the IR Receiver port or the IR emitter cable to the IR Flasher port of the receiver. The
source remote can control the source at the receiver side or the display remote can
control the display at the transmitter side.
• To set RS-232 mode see “Function Setting” Section, below. Connect the RS-232 ports
of a control system to the RS-232 ports of the transmitter and receiver to facilitate RS-
232 pass through. For details, see, RS-232 Control Connections Section.
• ETHERNET Pass Through: A built in Ethernet switch is provided on the Transmitter and
Receiver in order to pass through internet connectivity via the HDBaseT connection to
local devices at the end point.
6. Connect the DC 12V power cord provided.
7. Power on all attached devices.