7
5. INSTALLATION
CAUTION: Do not
connect power to the device until all other connections are made and the
unit is installed.
5.1. B-560-EXT-444-70 Transmitter Installation
1. Run category cable from the location of the transmitter to the remote location of the receiver.
2. Mount the transmitter in the desired location.
3. Connect the HDMI Out of a source to the HDMI IN on the transmitter using an HDMI cable.
4. Connect the RS-232 RJ-45 with CAT5e/6 using DB9-M-RJ45-ADPT from a control system
if being used.
5. Connect an IR control system to the IR receiver and/or IR flasher if being used. Refer to Section 6.2.
6. Connect the patch cable from the router or network switch to the ethernet port (RJ45).
7. Connect the 12V DC, 2A power supply to the latch-locking power jack, unless PoC is being
used to send power from the receiver. DO NOT plug the power supply into an AC outlet
until Receiver Installation is completed.
5.2. B-560-EXT-444-70 Receiver Installation
1. Run category cable from the location of the transmitter to the remote location of the receiver.
2. Mount the receiver in the desired location.
3. Connect the category cable to the receiver.
4. Connect an IR flasher and/or IR receiver if being used. Refer to Section 6.2.
5. Connect an HDMI cable from the HDMI Out of receiver to the display.
6. Connect the RS-232 RJ-45 with CAT5e/6 using DB9-M-RJ45-ADPT to an RS-232
controllable source if being used.
7. Connect the ethernet RJ45 to an ethernet enabled device if being used.
8. Connect the 12V DC, 2A power supply to the latch-locking power jack, unless PoC is being
used to send power from the transmitter.
9. Connect the power supply to the AC outlet.
