© 2012 Binary
B-500-EXT-330-RS-IP Installation and Users Manual
pg.7
4.2. B-500-EXT-330-RS-IP Receiver
DTE
ON
DCE
SERVICE
RS-232
5 3 2
LINK
HDBaseT
1
2
ON
+24V DC 1A
INPUT
PWR
HDMI OUT
ETHERNET
1
2
3
4
ON
SERVICE
RS-232
5 3 2
LINK
HDBaseT
DTE
DCE
1
2
ON
7
8
10
5
6
9
1. IR Receiver In (3.5mm {1/8”} Mono)
Connect an IR Receiver to send IR signals to
the Transmitter from the remote location.
In9V to power IR Receiver.
2. IR Flasher Out (3.5mm {1/8”} Mono)
Connect an IR Flasher to transmit IR signals
sent from the remote location.
3. HDMI Out to Display(HDMI)
Connect an HDMI cable to the HDMI In of
the display or AV Receiver.
4. Ethernet (RJ45)
Connect to an IP device to receive Ethernet
signals from the Transmitter.
5. Power LED
Indicates current state of Power, illuminates
RED when power is applied.
6. Latch-Locking Power Jack
Connect to the included 24V DC 1A Power
Supply.
7. RS232 Operation Mode Dip Switches
Switch 1: Configures RS232 DB9 connection
pins for DCE or DTE communication.
Switch 2: Configures RS232 DB9 connection:
ON for Pass-Through (normal operation) or
SERVICE for Firmware update.
See section 5.3.1.1 RS232 Operation Mode.
8. RS232 Control (DB9)
Connect to an Automation System RS232
control port to send RS232 signal to the
Receiver.
See section 5.3.1 RS232 Control (DB9)
Connection.
9. HDBaseT Link to Transmitter (RJ45)
Connect to HDBaseT RJ45 on Transmitter;
this connection follows standard TIA/EIA-
568B.
10. Signal Link LED
Indicates link status with Transmitter;
illuminates GREEN when sync is present. Blinks
when in Low Power Mode.