B-100 HDMATRIX Installation and Users Manual 4X4 & 8X8
© 2011 Binary
pg.9
3.3.1 IR Receiver Connection
Pin out configurations for IR receivers and Automation Systems vary. Before connecting to
this input, review this section carefully in order to match the pin outs for the HDMatrix. Before
connecting an IR Receiver or to an IR Automation System, verify that the HDMatrix is OFF to
ensure proper operation when connected.
3.3.2 Connecting to an IR Automation System/Connecting block
When connecting to an IR Automation System or connecting block, the 12V DC (Sleeve)
must not be connected. Connections of this type require the use of the included Stereo
to Mono dongle or a custom cable made. A mono 3.5mm cable should not be used as it
will short out the 12 VDC to GND, and will make the connection inoperable.
IR Signal
Tip
GND
Ring
12v DC
Sleeve
IR Signal
(Tip)
GND
(Ring)
12v DC
(Sleeve)
IR Signal (Tip)
12V DC (Sleeve)
GND (Ring)
To B-100-HDMATRIX
To IR Control System/
Connecting Block
IR Signal (Tip)
GND (Sleeve)
IR Signal (Tip)
(Tip)
12V DC (Sleeve)
GND (Ring)
(Sleeve)
IR Signal (Tip)
12V DC (Sleeve)
GND (Ring)
To B-100-HDMATRIX
IR Signal (Tip)
GND (Sleeve)
To IR Control System/
Connecting Block
3.3 Control Ports
3.3.2.1 Stereo to Mono IR Adaptor
3.3.2.2 Custom Cable Construction