TOP
Tilt slide rail forward
Fasten from bottom hole
FRONT GRID ASSEMBLY
Parts needed:
4 of
#1
2 of
#3
1 of
#2
STEP 1
4 Horizontal crossbars
(#1)
inserted through
1 center vertical
(#2) Note:
Slide horizontal
crossbar into left side of center vertical
following direction of arrow until alignment dimple
meets center vertical (see enlargement).
STEP 2
Two corner vertical
(#3)
inserted through
horizontal crossbars
REAR GRID ASSEMBLY
Parts needed:
4 of
#1
1 of
#2
2 of
#3
STEP 1
4 Horizontal Crossbars
(#1)
inserted through
1 center vertical
(#2)
Note:
Slide horizontal
crossbar into right side of center vertical following
direction of arrow until alignment dimple meets
center vertical.
STEP 2
2 Corner verticals
(#3)
placed on horizontal
crossbars.
SLIDE RAIL ASSEMBLY
STEP 1
8 Horizontal slide rails
(#7)
inserted in rear grid.
Tip:
If necessary, tap horizontal slide rails to be
sure slide rails are fully inserted.
STEP 2
Fastening horizontal slide rails
(#7)
in rear grid
using 8 –
#06
x
½
” fastening screws
(#1)
.
Note: Start at top row and work down.
Use only one fastener – bottom hole only.
All horizontal slide rails fastened to rear grid.
Note: Fastener in bottom hole only
