BIMG Metvisa DG.10, Instruction Manual, Page: 6 / 21

6
WARNING!
The installation and the place where it will be set must comply with the rules of prevention
of risk and safety at work (Regulatory Standard present on your country)
.
The manufacturer is not responsible for possible direct or indirect damages caused by non-
compliance with rules and instructions in this manual
.
3.2 Electrical Connection
The device is supplied with a power cable to be connected to an electrical outlet. If the power
cable is damaged, it must be replaced by a new cable. The exchange must be carried out by the
manufacturer, dealer or qualified person in order to avoid risks.
The power cord plug varies depending on the country. The installation of the device must be
done by a technician qualified for this function and always observing the current regulatory standard
of the country, in special about ground connection (if applicable).
The equipments are supplied with an equipotential grounding terminal located in the case,
near the structure of the appliance.
The post identified in the figure below is an additional guard for the
grounding that is provided in the mains, it must be connected to a
grounding terminal bar, regardless of the connection to the mains, and
other products that have accessible metallic parts. And which are stationary, must also be
connected to this bus as well as the service bench itself, in case it is of metallic material . In
this way all these products will be under the same electrical potential avoiding undesirable
currents of leakage.