Bimar PISOLO SC120, Instruction Book, Page: 20 / 48

20/48
there's no risk of tripping, to prevent people
from accidentally being injured.
2. Properly secure the blanket with latches /
cords (NOT supplied), pass the centre strap
under the central part of the mattress and
through the central eyelet on the other side.
Tie securely.
3. Pass the strap at the end under the bottom
corner of the mattress and through the lower
centre eyelet, pass it under the bottom corner
of the mattress and through the lower side
eyelet. Tie securely.
4. Repeat the procedure in point 3 for the upper
strap.
USE
Before each use, ensure that the appliance is in good working order, and that the
power cord is not damaged: if the cord is damaged, it must be replaced by the
manufacturer or its service centre or by someone with a similar qualification in order
to prevent any risks.
DO NOT place the controls under the pillow or blankets when in use.
It is suggested to turn the electric blanket on one hour before going to bed.
The cord of the electric blanket has the switch (D) that regulates different power
levels, that is, allowing it to heat the bed to the ideal temperature depending on the
temperature of the room, and also according to personal preference.
Using the appliance with0-1-2-3 Switch. The switch allows to select 20W of power in
pos. 1, 30W in pos. 2 and 60W in pos. 3, and switches the electric blanket off when in
pos. "0". For use, follow these instructions.
1. Ensure that the switch is in the "0" position (off), insert the connector at the cover
socket: lift the clip, slide the connector firmly and press the clip until it locks (see
figure below) , and then plug it into the plug point.
2. Select the power setting with the switch.
3. Before going to bed, turn off the appliance by turning the switch to “0” (off), and
unplug the appliance from the plug point. Warning: To turn off the blanket
completely, remove the plug from the plug point.
For continuous use, select the lowest heat setting “1”.