Bimar M004-L16D3F, Instruction Booklet

Page: 17 / 48

17/48
Use
Attention: the fan can be used only when completely and correctly assembled, that is
complete with its base.
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if
the power cord is damaged, it must be replaced by the manufacturer or a competent qualified
electrician or a person with similar qualifications, in order to avoid any risk.
The fan's functions can be controlled either with the keypad located on the control panel or
with the remote control. The remote control must be pointed at the control panel; for the first
use take off the tab transparent plastic of the batteri’s side (type AAA).
Do not allow children to replace batteries.
Do not mix new and used batteries or batteries of different types.
Should the remote control not be used for long periods remove the batteries.
Insert the plug in the socket.
Ventilation:
1)
To turn the fan on, press the key on the remote control “SPEED” or the control panel
“ ”.
2) To select the desired speed in normal mode “ ”, repeatedly press the “ ” or
“SPEED” key: on the control panel shows the selected speed (
= min; = med; =
max) .
Horizontal oscillation (right-left): this is controlled by the “SWING” key on the remote control
or the pushbutton panel (14). To eliminate this motion, press the “SWING” key again.
Vertical inclination (high-low): it is regulated by gripping the motor body and orienting it in
the direction desired; throught the screw (10) to lock the body in the desired position.
Timer: this function allows setting the operating time and the fan will automatically stop at
the end.
•
To set the operating time, repeatedly press the “TIMER” key on the remote control: every
time the key is pressed, the time set is changed and the indicator light on the control panel
lights corresponding to the time selected (0.5 hour, 1 hour, 2 hours, 4 hours, ecc….): the
maximum time is 7,5 hours. To deactivate the timer, press the button until the timer turns off.
-
Mode: the three modes are selected by pressing the “MODE” (15): button:
1.
“ ”: constant ventilation
2. Sleep: (symbol ), this mode reduces ventilation speed from one speed to the lower speed
every half hour, in details:
- Maximum speed set, lamp “ ”, cycles 30 minutes: the fan will run at intermittent
max/medium/minimum speed; then after 30 minutes the cycles are: the fan will run at intermittent
medium/minimum speed and turned off, and the signal lamp on ( ) , then the cycles are: speed
minimum and off, and the signal lamp on ( ) , and then will switch to low speed until the unit is
turned off