-
Rapid (comfortable warmth/2000W) and the display shows the "
" symbol.
In Eco and Rapid modes, using a Smartphone only, the temperature can also be
changed, but any difference between the set and room temperatures will always
function in the mode set previously, Eco or Rapid.
-
“Auto”: the
and
buttons are used to set the room temperature (7-38°C); press
the
button to increase or the
button to decrease. Depending on the
difference between the set and room temperatures, the programme activates the Eco
(1000W) or Rapid (2000W) power or the fan only. When the temperature set is 1-4
degrees from the room temperature, the “Low” function is activated, but if the
temperature set is
>
4 degrees from the room temperature, the “Rapid” function is
activated; if the difference is 0 or less, only the fan operates.
-
Fan : the “
” symbol appears on the display and the fan will work for about 20
seconds, in order to cool the device completely.
-
-
Defrost: the “
” symbol appears on the display: this function allows the fan heater
to be operated in Eco (1000W) mode, when the room temperature falls below +6°C.
•
Weekly programming: (only activated via Smartphone): sets: the on/off periods for each
day of the week and the temperature required. Programming may be: timer ON, timer
OFF or timer ON/OFF, in which the on-off periods are set for just once or for every day
of the week, and the temperature is selected (07-38°C).
•
Anti-overturning switch: stops operation if the device is overturned.
•
Safety device to stop operation if case of overheating: to return the device to operation,
remove the plug from the power socket and wait for it to cool (about 10/20 minutes),
connect the plug and switch it back on.
•
To deactivate the fan heater press the “
” button; the fan will operate for about 20
seconds to cool the device completely. Then set the switch on 0 and remove the plug
from the socket.
Use
First use: to eliminate the "new smell” operate the device for 10/15 minutes at maximum
power (Rapid): the room should be ventilated during this procedure
•
Connect the plug to the power socket and press the switch on the rear to the “I”
position; some "beeps" will be heard. The device will switch to standby mode and the
red light remains on.
•
Press button “
” to activate the device and select the functions required.
•
To deactivate the device, press the "
" button: the fan will operate for about 20
seconds (the countdown will start) to cool the device completely (if Eco/Rapid/Auto
mode was selected). Then set the I/0 switch on 0 and remove the plug from the socket.
During long periods of inactivity, remove the plug from the electric socket.
CLEANING AND MAINTENANCE
Warning: before cleaning the appliance, remove the plug from the power socket and wait
for it to cool.
