Bimar FSP40D, Instruction Booklet, Page: 21 / 60

21/60
are intermittent: “ Sleep- ” and “ Natural ”. To activate "Natural" mode,
press the button until the corresponding indicator light displays on the
control panel: the three speeds cycle randomly (each cycle lasts about 90
seconds). To activate “Sleep” mode, press button and the control panel will
light up: this mode reduces ventilation speed from one speed to the lower
speed every half hour. The cycles are:
-
Maximum speed (H) set: the fan will run at maximum speed for 30 minutes,
then at medium speed for 30 minutes and then will switch to low speed until
the unit is turned off manually or by the timer which has been previously set.
-
Average speed (M) set: the fan runs at medium speed for 30 minutes, it
changes to minimum speed for 30 minutes and then turns off.
-
Minimum speed (L) set: the fan runs at minimum speed for 30 minutes, and
then turns off.
-
Spray: press the “ ” steam button and the corresponding symbol will light
up
-
Timer: sets the time of operation, after which the unit will stop. Repeatedly
press “ ”: each press changes the time (from ½ hour to 7 hours and a half
with ½ hour intervals), the selected time will light up on the control panel. To
deactivate the timer, press the button until the display time disappears.
-
Oscillation (right-left): press “ ” to activate (symbol lit) or deactivate
(symbol off), “ ”.
-
Height adjustment: unscrew the ring nut (15); raise or lower the main unit to
the appropriate height and then lock the ring nut.
To operate the fan, plug it in to the mains: the “ ” symbol will light up
(indicates stand-by status) and a you will hear a "beep"; press “ ” to activate
the fan and select the desired functions.
Press “ ” button to deactivate the appliance: the “ ” symbol remains lit. To
turn the appliance off, remove the plug from the mains.
If the appliance is not being used for long periods of time, remove the plug from
the plug point and empty the water tank.
CLEANING AND MAINTENANCE