Step 16
NAIL
(62 used in this step)
1N
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
å
Carefully turn your unit onto its front edges. Unfold the BACK (M)
and lay it over your unit.
å
Make equal margins along the two side edges of the BACK (M).
The bottom edge of the BACK (M) and bottom surface of the
BOTTOM (I) should be even. Push on opposite corners of your
unit if needed to make it "square".
å
Fasten the BACK (M) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over
the UPRIGHTS (C).
å
NOTE: Perforations have been provided for access through the
BACK. Carefully cut out the holes needed.
The top edge of the BACK should be down
slightly from the top edge of the TOP.
M
I
These holes must line up
over the UPRIGHTS (C).
421192
www.sauder.com/service
Page 21
Unfi
nished sur
face
