PL25H Owner’s Manual
Part No 100382
Form No F072215B
6
PACKING CHECKLIST
Your Billy Goat is shipped from the factory in one carton with the handles and cables detached.
PUT OIL IN ENGINE BEFORE STARTING
ASSEMBLY
READ
all safety instructions before assembling unit.
TAKE CAUTION
when removing the unit from the box.
30
NOTE
: Items in ( ) can be referenced in the Parts Illustration and Parts List on pages 10-11.
1.
REMOVE
the two bolts and nuts from the hardware bag (item 4 and 38).
2.
ATTACH
the upper handle (item 73) into the side braces with the hardware (items 4 and 38). NOTE: The bail should be
facing downward.
3. ATTACH
the tine lift cable (item 16) to the Tine lever (item 30) upper hole on the handle (see
Fig. 1 handle
below and
reference Parts Illustration page 10) by inserting the pin (item 55) into it in the hole closest to the end of the handle. Retain
with Rue ring.
4.
ATTACH
the bail cable (item 54) to the bracket on the handle (item 74) by sandwiching the two nuts on the bracket and
tightening. Install cable adjuster (item 52) by threading it on the end of the cable until thread begins to show.
NOTE
:
Protruding portion of the threaded adjuster must be facing the operator when installed
. Check to make sure the
cables are functioning properly before operation and not binding. If adjustments are needed for belt tension on the bail
cable, loosen the nuts and move the sandwiching position up or down for the desired tension.
NOTE
: if the tension is too
loose the tines will not engage and if it is too tight premature wear could happen to the belt.
5
.
CHECK
engine oil level and fill to proper level. Also check oil in gear reduction reservoir and fill if necessary. See engine
owner’s manual for type and amount of oil to use.
6
.
SET
the engine stop switch, located on upper handle, to the
ON
position.
Boxing Parts
Checklist
Owner’s Manual
100382
Engine Manual Per
Model
Honda
PARTS BAG & LITERATURE ASSY
Warranty card P/N-
400972, Owner’s Manual P/N-100382, Declaration of Conformity P/N-381503, General Safety and
Warnings Renovation Manual P/N-100295
Attach (item 16) cable
here
Fig. 1
handle
