KV PUSH Owner’s Manual
Part No 891203
6
ASSEMBLY INSTRUCTIONS
NOTE
: Items in ( ) can be referenced in the Parts Illustration and Parts List on pages 10-11.
1.
ASSEMBLE
the upper handle (Item 11) to the lower handle
(Item 10). Line up the holes on the upper and lower handles.
Insert bolt (Item 49) with threads facing inside. Fasten the
handles together with the black knob (Item 57). Thread the
knob
onto the bolt, and hand-tighten by rotating the knob
clockwise.
Repeat this step on the other side of the handle to
secure the
upper handle to the lower handle.
2.
ATTACH
the throttle lever (Item 23) to outside the handle
tubing.
Insert bolt (Item 39) with washer (Item 36) from the
inside, with
threads facing out. Secure the throttle lever with
second washer
(Item 36) and nut (Item 37). Tighten with a
7/16” socket and
wrench. Once attached, use a zip-tie to
secure the cable to the
handle. Trim excess zip-tie with snips.
3.
UNFOLD
the debris bag (Item 21). Locate the quick
disconnect
scoop (Item 12). Insert the quick disconnect
scoop into
the bag
through the large opening. Maneuver the
quick disconnect scoop
through the bag and out the small
opening.
Tighten the ratchet
strap over the quick disconnect
scoop to secure. Close the large
opening of the debris bag.
4.
INSTALL
the debris bag onto the housing discharge chute.
Open the discharge flap (Item 6) at the back of the housing.
Slide the quick disconnect scoop downward onto the housing
discharge chute.
5.
ATTACH
the debris bag to the upper handle. Note the bag
straps in each of the four corners of the bag. Each strap has
an
eyelet
(B, Fig 2)
. Use the eyelets to hang the bag onto the
upper
handle
posts (Item 13).
6.
CONNECT
spark plug wire from the engine to the unit.
7.
FILL
the engine with oil and gasoline before starting.
891203_
F
_HI
NOT
FOR
REPRODUCTION
