BC26EU HYDRO-DRIVE Owner’s Manual
Part No 501606
8
501606_C_HI
CUTTING
OPERATION
1.
Press blade clutch handle down (See
Fig. 4)
to engage blade. Allow
blade to spin up to normal operating speed.
2.
Pull Forward (See
Fig. 5
) or Reverse Drive lever (See
Fig. 6
) up to
engage transaxle in desired direction.
DECK HEIGHT ADJUSTMENT
1.
To raise and lower the cutting height on the deck, pull the knob upwards
and rotate the handle clockwise to raise the cutting height and counter-
clockwise to lower the cutting height. DO NOT ADJUST HEIGHT WITH
THE BLADE RUNNING
CLEARING
A
CLOGGED
DECK
DISCONNECT
spark plug wire before servicing unit.
1.
Shut engine off and wait for blade to stop completely.
2.
Disconnect spark plug wire.
3.
Remove clog from cutting deck.
WEAR
durable gloves. Clog may contain sharp materials.
4.
Reconnect spark plug wire.
SHUT DOWN
1.
Release drive lever (
Fig. 5/6
) to disengage transaxle.
2.
Release blade clutch handle (
Fig. 4
) to disengage blade.
3.
Move the throttle to the slowest possible position on the throttle control.
*****TIPS*****
The best performance is achieved when cutting in dry conditions. The quality of the cut is directly related to ground speed during
cutting. Under most conditions cutting should be done at a slower ground speed. Fast speeds should be reserved for conditions
where weeds and brush are thinned out or not very tall. If the quality of the cut is not satisfactory, attempt at slower speeds.
Fig. 4
Left Handle
Fig. 5
Right Handle
Fig. 6
Left Handle
Fig. 8
Freewheel Lever
NEUTRAL/FREEWHEEL
1.
Identify the freewheel lever located in front of the right front
wheel when viewing from operator’s station.
2.
Pull lever to initiate freewheel motion.
3.
Push lever in to initiate driver enabled motion.
NOT
FOR
REPRODUCTION
