Billy Goat DL1302H, Owner'S Manual, Page: 4 / 12

4 billygoat.com
I.D. Item DL1302H,
DL1402SE,
DL1802V
DL1802VE
O Nut (Elbow) 8165003 8165003
P Bolt (Band Hose Boom) 8041013 8041013
Initial Set-Up Assembly Hardware
4
I.D. Part Number QTY
J 8172020 4
K 8041032 2
L 8165002 2
M 8165001 1
N 8024058 8
O 8165003 8
P 8041013 1
Q 791027 2
R 791057 1
Assembly
Mounting Main Unit
This unit must be securely mounted to a trailer, truck bed,
or other similar surface before use. Do not use this unit in
a freestanding position. Unit is not stable until it has been
secured in place. Secure unit by bolting through the base of
the unit and through the mounting surface using 3/8" bolts,
with washers and locking nuts.
5
Initial Set-Up Assembly
1. Securely attach unit to the bed of a truck or to a trailer, so
that the exhaust discharges into an enclosed container.
2. Attach the hose boom to hose by sliding the boom
through the rings on the top of the housing.
3. Slide the hose onto the housing intake, ensuring the shut
off switch is positioned under the hose or the vacuum will
not start (See the Safety Interlock System section of this
manual). Then place the ratchet strap over and around
the end of the hose to secure it to the housing. Note: The
ratchet strap is located in the Parts Bag and Literature
Assembly.
4. Assemble nozzle handle to nozzle intake using bolts,
washers, and nuts (items J, K, and L in Figure 4).
5. Attach assembled nozzle to hose using hose clamp.
Before tightening hose clamp, position nozzle handle
upward when hose is stretched to prevent twisting. Load
on hose assembly during operation.
6. Assemble hose band around hose and secure chain
between the flanges of the hose band using capscrew
and lock nut. Attach the chain to the boom and the screw
on the hose band. See "Adjusting the Hose Boom" for
more information.
7. Securely attach exhaust elbow with the nuts and bolts
(items N and O in Figure 4).
NOT
FOR
REPRODUCTION