SC180HEU Owner’s Manual
Part No 371515
Form No F102215B
9
MAINTENANCE
Note
: Item numbers in ( ) will be referenced in the Parts Illustration and Parts List on pages 12-20.
PERIODIC MAINTENANCE
Periodic maintenance should be performed at the following intervals (disconnect spark plug during maintenance).:
Maintenance Operation
Every Use
(daily)
Every 5 hrs
or (daily)
Every 25 Hrs Every 50 Hrs
(Yearly)
Every 150
Hrs
Inspect for loose, worn or damaged parts.
Check for excessive vibration
Inspect belt for wear
Engine (See Engine Manual)
Grease pivot points
*Use NLGI grade 2 multipurpose lithium based
grease
Sharpen Blade
Replace blade and traction belts
Note
: Blade, and drive belts and chains are normal wear items. These should be inspected on a regular basis
and replaced if worn. Also see your Billy Goat Dealer for servicing your machine.
BELT REPLACEMENT
Note
: See
Fig. 3
for belt configuration
Switch off the engine and disconnect the spark plug wire before carrying out any
maintenance or repair work on the machine.
If a belt is worn or breaks it should be replaced as follows:
Remove all of the metal guards (items 15, 16, 21 and 17) to allow easier access to
the pulleys and belts.
Note
: see pages 12, 14, 16, 18 and 20 for part illustrations
BLADE BELT
1. Disconnect the spark plug, and then remove the guards.
2. Remove the master link on the drive chain (Item 133) to allow the belt (item
132) to be slipped past.
3. Loosen the tension on the pulley (item 35) by loosening the nut and bolt
holding it to the base. Do not completely remove the nut and bolt, as loosening
it will allow the pulley to shift.
4. Walk the old belt off of the clutch (item 18) if necessary.
5. Replace with the new belt and reapply tension to it on the pulley loosened in
step 3 then tighten it. Do not put too much tension on the belt as this will lead
to premature wear.
6. Reinstall the chain onto the wheel drive by reinserting the master link.
7. Reinstall the guards.
8. Check for proper operation.
133
131
132
130
ON UPPER GROOVE
OF CLUTCH
ON LOWER GROOVE
OF CLUTCH
See page 19 for parts illustration
Fig. 3
Fig. 4