Bilanciai DD1050, Operation, Maintenance And Installation Manual

Page: 7 / 112

7
DD1050
1 INTRODUCTION
1.1 foreword
• The aim of this manual is to provide the operator, through the use of text and illustrations,
with essential information regarding the installation, correct operation in safe conditions, and
methodic maintenance of the weighing system.
• Always keep this manual at hand! Always observe the instructions contained in the manual!
• Safe operation of the system is the responsibility of the operator, who must be fully familiar
with it.
• The user is responsible for ensuring that the installation conforms to the applicable
regulations.
• The equipment must only be installed by specialised personnel who have read and understood
this manual.
• “Specialised personnel” means any personnel who, by virture of the training they have
received and their professional experience, have been explicitly authorised by the “System
safety supervisor” to install, operate and service the system.
• Contact your nearest Service Centre if problems occur.
• Any attempt on the part of the user or unauthorised personnel to dismantle, modify or
tamper with the terminal is prohibited. Any such attempt shall invalidate the warranty and
relieve the manufacturer from all liability for any damage or injury to persons or property.
• It is also forbidden to alter or remove the data plates and seals on the terminal. Make sure
that all plates and seals are present and legible, if not contact the After-Sales Service.
• The Manufacturer shall not be liable for any damages caused by incorrect handling of the
terminal.
• The information and illustrations contained in this manual were up to date at the time of
publication.
• The manufacturer is committed to a policy of continuous product improvement and parts of
the system may therefore be subject to modification.
• All the technical information contained in this manual remains the exclusive property of the
Manufacturer and may not be disclosed to third parties.
• No part of this document may be reproduced or transmitted in any form, including publication
in computerised form or on the World Wide WEB, without the explicit written permission of
the manufacturer.
• This manual may not be used for purposes other than those directly related to installation,
operation and maintenance of the terminal.
• In order to more clearly describe certain maintenance or adjustment operations, some of
the illustrations in this manual show the weighing system with the safety guards removed.
Under no circumstances may the system be operated in these conditions. The safety guards
may only be removed for the time strictly required to carry out the required repairs or
maintenance work after which they must be fitted back in place.