11
Connect speak
ers using wire leads in Harley OEM wire harness:
Harley wire colors for fairing speaker connections
Air cleaner side
Gr
ay/R
ed Stripe
Speak
er positiv
e (red dot or “+”)
Air cleaner side
Light Green/Black Stripe
Speak
er negativ
e
Kick stand side
White/Or
ange Stripe
Speak
er positiv
e (red dot or “+”)
Kick stand side
Light Green/White Stripe
Speak
er Negativ
e
6.1
Plug Black cable from Bik
etronics (Or
ange) module into jack in rear of r
adio
.
On Son
y r
adios this cable must point str
aight up tow
ard windscreen.
*
BT1005 with K
en
wood or JVC: Connect corresponding light blue/y
ellow wires, and tape off the
black cable with electrical tape to prev
ent shorting.
6.2
Plug antenna lead (y
ellow antenna wire or OEM Harley antenna) in rear of r
adio
.
6.3
Plug r
adio wire harness Black connector into rear of r
adio
6.4
Plug White connector into harness from Bik
etronics (Or
ange) module.
If one or both harnesses do not ha
ve the white connector
,
see page 8.
6.5
Depending on model y
ear
, mak
e connection between Bik
etronics module and Harley wire harness:
1998-Present: plug Harley (Black) 23 pin connector into Bik
etronics module.
1996-1997: plug Harley 8 pin and 12 pin connectors into Bik
etronics module.
6.6
1988-1997: R
adio memorey and r
adio power fuses must be changed to a 10 amp r
ating for r
adio
to oper
ate. Do not ex
ceed 10 amp r
ating. Consult Harley
-Da
vidson shop manual for locations.
Disconnect battery before proceeding!
Failure to do so will cause a short to ground and is not covered under warranty!