The EV01A unit installation
The unit has several connections depending on the con+iguration you purchased, however all units will have the main system cable with
the gray CB connector and the 3 pin power connections this connects to the system connector on the EV01A unit (Fig 3)
!
1. Start in the trunk by removing the radio cover panel and unplugging all the system plugs from the radio
2. Remove the 4 screws holding the radio in place and remove the radio.
3. You can now plug the EV01A connector into the motorcycle CB connector on the side of the radio (Fig 1).
4. Locate and connect the 3 pin motorcycle power connection located near the radio unit (Fig 2).
5. At this time you can install your antenna following the items instructions and route any cables to your GPS or radar detector etc.
6. Screw the antenna cable onto the Evolution unit and make your antenna connections.
7. Firmly plug the system connector into the EV01A unit and place the unit in the space under the radio.
8. Re+it the radio and make sure all original connections are correctly +itted.
NOTE. Ensure the base of the trunk is clean when you place the EV01A unit in the CB well of the trunk , you may use some +ixing tape
but this is not necessary.
Summary of Contents for EV01A
Page 1: ......
Page 8: ...FIG 1 FIG 2 FIG 3 ...
