U
N
IT
How to use Digital Torque Ratchet
Do not
press "M" and " " button together please.
The system will enter into Calibration Mode.
A
Battery Install and Replacement.
1. 1 x CR2032 Battery
2. Keep the end thread clean and dry for a good contact.
3. Open the battery cap.
4. Remove the old battery.
5. Install 1 CR2032 Battery in the housing. ("+" sign facing upwards).
6. Screw on the battery cap.
Battery Cap
Note
1. When battery is low a "
" icon will light.
2. Remove the battery if stored for a long period of time.
3. Battery life depends on battery quality and the amount of lights and alarms that are used.
4. Typical life is up to 55 hours
B
Power On.
1. Press and release the "
" button to turn the ratchet on. The LCD panel shows "
"
or "
".
M
Mod
kg-cm kg-m in-lb ft-lb N-m
-
SET MAX.
+
Digital
Ratchet
2. After 2 seconds the L.C.D panel show "00.0".
3. Swing the ratchet.
4. The L.C.D displays the torque value measured.
Note
If you do not use the ratchet for 80 seconds the digital ratchet will automatically shut off.
05
