< Tourer >
The Bike Shield Cover assembly
- STEP 6 -
- STEP 7 -
AP Tube
a
a
REAR
FRONT
3
2
1
4
5
6
Pocket for tube
Pocket for tube
AP
T
ube
a Identify front and rear side of the cover. Cover’s
rear side
- Look up the position of two pockets for B Tube as shown.
b “FRONT” and “REAR” are stamped on each side.
1 Put I Tube through pocket and connect to AP Tube with both side of I Tube.
2 Put CI Tube through pocket and connect to AP Tube with both side of CI Tube.
3 Start by pulling the
front side
Large Velcro flap under the AO Tube and attaching together.
4 , 5 , 6 Put each pair of C Tube through left and right side of pockets and connect with each AP Tube.
Front Large Velcro
1
2
Steel Washer
Rear Large Velcro
3
4
5
5
5
5
5
7
6
1 , 2 Put B Tube through pockets on left and right side of cover.
3 Assemble AP Tube with both side of the B Tube.
4 Pull the rear side Large Velcro flap under the rear side of AP Tube and B Tube, then attach Large Velcro flap together.
5 Attach Velcro straps.
6 , 7 Insert the Steel Cover Ring to the C Bolt Set, insert Steel Washer and fasten loose proof nut.
* You can use Padlock on the right or left side of Tube Binding Bar.
* Adjust tension with the front and rear Velcro flaps as well as the side Velcro straps to fit cover properly on the frame.
AP Tube
Steel Cover Ring
C Bolt Set
Padlock
Assembly for 1 , 2 , 4 , 5 , 6
B Tube
5
Pocket for B Tube
I Tube
CI Tube
4 - 4
b
b
