13
BIJUR DELIMON INTERNATIONAL
BA_2017_1_GB_PVB
9.
ACCESSORIES
Close / open of outlets
DESCRIPTION
ORDER
NO.
MATERIAL
Plug screw + clamp ring mounting
741611851
steel ZnNi
Clamp ring
735113223
brass
Plug screw M10x1
741615741
steel ZnNi
Sealing DIN 7603 - A 10x13,5
727121094
copper
Ball
71961
4114
Headless pin
741072644
Accessories for manual lubrication / emergency lubrication
DESCRIPTION
ORDER NO.
MATERIAL
High pressure grease nipple, tapered DIN 71452 – A G 1/8“ for
divider inlet
736831514
A3C
T-piece 1/8“ BSP
73449V066
A3C
Additional accessories like manual grease guns, hoses and fittings you can find within our brochure “Lubrication Assistance”.
10.
ASSEMBLY, INSTALLATION AND COMMISSIONING
WARNING
Assembly of the PVB distributor may only be carried out by qualified personnel. An appropriate commercially available tool
must be used to assemble the pipelines and cutting ring fittings.
Please contact our service department if necessary. We can provide service engineers or supervisors for assembly, training
and induction – either at a flat rate or invoiced per day.
Installation position and mounting:
The progressive distributor is mounted by means of two mounting holes Ø 7, preferably with M 6 x 40 hexagonal bolts and
washers. The mounting bolts are not normally included in delivery and must be ordered separately if required (see table on
page 13).
o
The PVB distributor can be fitted in any mounting position without limitations.
The side with the engraved outlet numbering should face upwards (to be
permanently visible). The pipeline ports are thus on the upper side, which makes
it easier to fit the pipes.
o
The distributor must be mounted in a stress-free position on a flat surface.
o
Weld-on plates (optionally available) must only be welded on without the distributor fitted.
to open
c-connection
to close b–connection
or outlet
to close b-connection
