BIJUR DELIMON INTERNATIONAL
(919) 465 4448
LOCAL
(800) 631 0168
TOLL-FREE
(919) 465 0516
FAX
www.bijuRdELimOn.COm
2100 Gateway Centre blvd., Suite 109
morrisville, nC 27560
35511 • R2
05/09
2
Instructions
insert the battery pack into the charging socket of the charger. Then, plug the charger into the
1.
nearest 120 V, grounded, electrical outlet.
The green light on the charger will automatically turn on.
2.
depress the
3.
SET
button on the charger. The green light will automatically go out, and the red
light will turn on indicating the charger has switched to the charge mode.
Charge the battery for one hour before using the gun.
4.
when the battery pack is fully charged, the red light will automatically go out, and the green light
5.
will turn on. Remove the battery pack from the charger, and disconnect the charger from its
electrical outlet.
Load the grease cartridge and pull the trigger to dispense grease.
6.
when the battery pack requires recharging, a one hour charge allows the tool to operate at full
7.
power. do not recharge the battery pack longer than one hour, as damage to the battery pack
and/or charger will occur.
Maintenance
do not force the tool – use the correct tool for your application. The correct tool will do the job
+
better and safer at the rate for which it is designed.
do not use the power tool if the switch does not turn it
+
ON
or
OFF
.
Any tool that cannot be controlled with the switch is dangerous and must be replaced.
+
disconnect the power tool from its battery pack before making any adjustments, changing
+
accessories or storing the tool. Such preventive safety measures reduce the risk of starting the
tool accidentally.
Store idle tools out of reach of children and other untrained persons. Tools are dangerous in the
+
hands of untrained users.
maintain tools with care. Properly maintained tools are less likely to malfunction and are easier to
+
control. do not use a damaged tool. Tag damaged tools “do not use” until repaired.
Check for misalignment or binding of moving parts, breakage of parts, and any other condition
+
that may affect the tool’s operation. if damaged, have the tool serviced before using. many
accidents are caused by poorly maintained tools.
use only accessories that are recommended by the manufacturer for your model. Accessories that
+
may be suitable for one tool may become hazardous when used on another tool.
Troubleshooting
Symptoms
Possible Cause
Remedy
Gun runs slow.
battery charge too low.
Recharge the battery.
Grease fitting clogged or corroded.
Replace the fitting.
Grease comes out of
the front of the gun.
Grease fitting clogged or corroded.
Replace the fitting.
Gun runs but no grease comes out.
no grease in gun.
insert new grease cartridge or bulk fill
the tube.
Air pocket in grease tube.
Partially unscrew tube until a ring of
grease forms at the threads, then
retighten the tube.
no lights on charger.
no electricity at the wall socket.
Check the breaker panel.
The temperature of the battery pack may
increase during use and shortly after use.
The battery pack may not accept a full
charge if it is charged immediately after
use. Allow the battery pack to cool to
room temperature before charging for
best results.
This gun has an external grease bypass
system that vents grease from the head
of the gun when the grease fitting is
clogged. When grease starts bypassing
out of the head of the gun
STOP!
CONTINUING TO PRESS THE TRIGGER
WILL DAMAGE THE GUN.
