6
Usage Instructions
English
Additional safety warning from the manufacturer
- Observe also other safety directions that are a part of each instrument delivery.
- Check the flexible lead and plug before each use of the instrument. Have the faults removed by an expert.
- The instrument should not be operated in damp, wet premises; during a rain, fog and snow in the open, and in environment with
a risk of explosion.
- Before putting the plug in the mains socket the switch should be in the “off” position.
- Take care of long hair and fashion accessories, work in properly buttoned-up clothes, without freely flowing parts.
- Secure the vessel with the mixed substance against moving on the floor.
- Always direct backwards the flexible lead from the instrument, Flexible lead should not be exerted by tensile stress and should not lie on
or pass over sharp edges.
- Take care that you take a safe and firm stand at work.
- Use the supplementary handle.
- Consider possible reaction torque.
2. Application
- Heavy duty gear system with large torque
- With 300 hours continued working time
- Paddle swing < 0.5mm without fatigue
- Maximum mixture loading 40L
- Suitable for mixing cement, paints, tile adhesive, glue etc
- Also available in 110V version
Model
MME1200
Voltage/Frequency 230V/50Hz
Input Power
1200W
1st Gear 150-300RPM
2nd Gear 300-650RPM
Two-section mixing paddle
600x120mm x M14
Accessories
No Load speed
Manufacturer reserves the right to change specifications without notice.
Specifications may differ from country to country
Technical Data
3. Instructions
Improper use may damage the instrument.
Observe therefore these instructions:
- Use a tool up to the specified diameter.
- Load the instrument in such a way that the speed would not drop considerably or that it would stop.
- Check if the data on the rating plate correspond with the actual mains voltage.
- Instrument scheduled for 110V/230V can be plugged to 110V/220V/240V mains.
3.1 Operation and Use
Fixing a whisk
-
Screw tools with thread M14 x 2 as far as possible in the tool mount and tighten properly with an open-end wrench from among
the accessories.
Switching on and off
- By pressing the switch button the apparatus is brought into operation and it stops when this is relieved.
Permanent run
- By pressing the switch button to the stop and simultaneous pressing the arresting pin permanent run is achieved.
- By subsequent pressing and relieving of the switch button, the permanent run is interrupted.
Unloading the tool (whisk)
- Fit a flat open-end wrench on the hexagon end of the tool (whisk) and unscrew the tool from the spindle by turning it to the left.
Caution
!
3.2 Electronic Motor Control
Starting current limiting
- The electronically controlled smooth start takes care that the machine starts without jerk. In this manner, the splashing of thin liquid
materials is prevent at the same time when switching on the machine.
- As a result of the machine's reduced starting current, a 16A fuse is sufficient.
