AS-i Safety Relay Output Module with Diagnostic Slave
1 EDM- and 2/1 safety inputs
Address Assignment
Subject to technical modififications; no responsibility is accepted for the accuracy of this information
© Bihl+Wiedemann GmbH
19
Internet: www.bihl-wiedemann.de • Flosswoerthstr. 41 • D-68199 Mannheim
phone: +49 621 33 996-0 • fax: +49 621 3 39 22 399
Is
sue da
te: 3
0.5.2
011
6.
Check slave’s ID2 code by using the hand-held addressing device or AS-i
Master. The code should be the same as the ones-digit of the address.
7.
Check slave’s IO code by using the hand-held addressing device or AS-i
Master. The code should be “7”.
6.2
Programming the AS-i address of the safety input slave
2.
The desired address can be programmed by using the hand-held address-
ing device or AS-i Master.
6.3
Programming of the AS-i address of the diagnostics slave
(AB Address)
2.
The desired AB address can be programmed by using the hand-held
addressing device or AS-i Master.
Warning!
The correct safety function of the device must be verified once installed within the pro-
tected machinery!
Programming of the safety address (safety input slave):
1.
Set the swiches of the device to SEL / PRG.
SEL
PRG
ON
RUN
Programming of the AS-i address of the diagnostics slave (AB address):
1.
Set the swiches of the device to SEL / RUN.
SEL
PRG
ON
RUN
Summary of Contents for BWU2236
Page 21: ......
